Here are the instructions for using a rolled hem presser foot:
-
Set up your machine: Raise the needle to its highest position, and remove the standard presser foot. Attach the rolled hem presser foot onto the machine by inserting the bar on the foot into the presser foot holder and lowering the presser foot lever to secure it in place.
-
Adjust the settings: Adjust the stitch length and width on your machine to create the desired rolled hem. The recommended settings for a rolled hem are a narrow zigzag stitch with a stitch length of 1.0 to 1.5 mm.
-
Fold the fabric: Fold the fabric over twice to create a small hem. The folded edge should be just wide enough to fit into the groove of the rolled hem presser foot.
-
Begin sewing: Start sewing at a slow speed, guiding the folded edge of the fabric into the groove of the rolled hem presser foot. Use your hands to guide the fabric smoothly through the foot as you sew. Be sure to keep the folded edge of the fabric in the groove of the foot to create a consistent, neat hem.
-
Continue sewing: Once you've sewn a few inches of the hem, stop and check the stitch length and width. Adjust if necessary. Then, continue sewing until you reach the end of the hem.
-
Finish the hem: Backstitch at the end of the hem to secure the stitching in place. Trim the excess thread, and you're done!
Remember to practice on scrap fabric before sewing on your actual project to ensure you get the hang of it.